3/8” forged steel with zinc-plated gold chromate
Spring tension safety latch 
1.30” throat opening 
Working Load Limit of 6,600 lbs

5/16” forged steel with zinc-plated gold chromate
Spring tension safety latch 
1.10” throat opening 
Working Load Limit of 4,700 lbs

Working Load Limit of 1,333 lbs
Steel fitting with electro-coated black finish to resist rusting
Bolt or screw to sidewalls, floors, ceilings, or wood studs

All C and J hooks are flame cut from 5/8" steel. They are designed to fit flat on truck trailer side frames for easy welding and will accept D-rings, web loops, cable or rope.

Working Load Limit: 6,670 lbs./3032 kgs.

Note: Strength is dependent upon the quality and integrity of the weld. Minimum welding requirements are 1/4" fillet weld around entire contact surface, and 1/8" penetration.

Weight: 0.7 lbs., 0.3 kgs.

All C and J hooks are flame cut from 5/8" steel. They are designed to fit flat on truck trailer side frames for easy welding and will accept D-rings, web loops, cable or rope.

Working Load Limit: 6,670 lbs./3032 kgs.

Note: Strength is dependent upon the and integrity of the weld. Minimum welding requirements are 1/4" fillet weld around entire contact surface, and 1/8" penetration.

Weight: 0.5 lbs., 0.2 kgs

Floor Chain Tie-Down with Standard Grade 43 Chain

Kinedyne's floor chain tie-down is for use on steel frame flatbed trailers with standard hardwood decks. It is a self-storing, convenient anchor point for securing loads. Welds to trailer cross member. It mounts flush with the standard hard wood trailer deck to prevent interference during loading or unloading.

Working Load Limit: 5,000 lbs./2270 kgs.

Minimum weld requirements are 1/4" filet weld around entire contact surface and 1/8" penetration.

Weight: 2.8 lbs., 1.3 kgs.

All C and J hooks are flame cut from 5/8" steel. They are designed to fit flat on truck trailer side frames for easy welding and will accept D-rings, web loops, cable or rope.

Working Load Limit: 6,670 lbs./3032 kgs.

Note: Strength is dependent upon the quality and integrity of the weld. Minimum welding requirements are 1/4" fillet weld around entire contact surface, and 1/8" penetration.

Weight: 0.5 lbs., 0.2 kgs

Slat Hook - 1,000 lb. WLL

Swivel J Idler Fitting - 4.75" long - 3,333 lb. WLL

The Aftermarket version offers the ability to convert any standard ratchet strap. The StrapPak® by Kinedyne offers a quick and inexpensive way to secure the loose end of your straps.Attach to any standard 2” ratchet strap Safely secure excess web on ratchet straps up to 30 feet in length Can be used on any open-air or enclosed trailer or utility truck You will never again have to use duct tape or cable ties to secure the loose end of your straps. The StrapPak also serves as a convenient storage solution for your strap when it is not in use

Bent Tarp Hooks made from 1/2" Steel Wire

Unfinished Light Oil

100 PCs Bag of Tarp Strap Hooks