Anchor Bolts Hardware for Concrete Installation

Box contains 3 Nuts and 3 Bolts. Bolt Part#: 11005, Nut Part #: 37018
Bolt, Hex Head, Size: 1/4" - 20 x 1"
Nut, Nylon Lock, Size: 1/4" - 20
Fits: ORWC-8-ERGO, FAB-10-ERGO, FAB-11-ERGO, LWC-14M-ERGO, RWC-8-ERGO

72" Wide Steel Truck Dockboards with a 20,000 lb. Capacity are constructed of high strength 55,000 psi steel.

*Choose your dimensions and optional add-on's below

84" Wide Steel Truck Dockboards with a 20,000 lb. Capacity are constructed of high strength 55,000 psi steel.

*Choose your dimensions and optional add-on's below

These dock leveler's are fully automatic loading ramp where there is no dock attendant needed. It consists of a lift by-pass for safety and toe guards on each side. As the truck backs against the twin actuating arms (bumpers) it pushes the carriage back. The dock and trailer doors must be raised for this process to work. As the carriage goes back the deck goes up. When the carriage bumpers contact the dock, the deck floats down to rest on the trailer. When the truck pulls out, the deck returns to level supported position automatically.

Electric Hydraulic Dock Leveler work great for high usage dock areas. The hydraulic design is state of the art and consists of a simple push of the button operation. The operator pushes and holds the "raise" button which activates the hydraulic pump and raises the deck. When the deck reaches the raised position the lip automatically extends. The operator releases the "raise" button and the deck descends to rest on the trailer. The control box includes a red emergency stop button standard. When the truck pulls away, the deck descends to full down position, trips the limit switch and returns automatically to the level cross traffic position. Includes telescopic steel toe guards on both sides, flush with platform edge, service range of +/- 12" and two (2) laminated bumpers. 460V 3-Phase standard. Uniform capacities available up to 80,000 pounds, contact factory.

72" Wide Steel Truck Dockboards with a 10,000 lb. Capacity are constructed of high strength 55,000 psi steel.

*Choose your dimensions and optional add-on's below

Truck trailer dock seals for 8X8 doors have a 36 ounce reinforced vinyl facing. Chemically sealed ends to protect from moisture penetrating.

*See more below....

Dock seals 8X9 have a 36 ounce reinforced vinyl facing. Chemically sealed ends to protect from moisture penetrating.

Dock Shelter is used with doors up to 10'W x 10'H.

The dock seal and shelter combination standard use is for a 96" wide X 120 inch high door.

Retractable Dock Shelter fits up to a 120"W x 120"H door.